Author Topic: Battery  (Read 1692 times)

0 Members and 1 Guest are viewing this topic.

Offline Dolittle

  • Tricycle
  • Posts: 26
  • AREA: Northeast Area
  • COG#: 364
  • Membership Level: Active
Battery
« on: February 01, 2009, 09:00:00 pm »
Hi every one!    Where can i charge the battery on the 14 with out pulling it out of the bike? Thanks.  
Richard McClelland

Offline Paul_Burks_GA

  • Tricycle
  • Posts: 10
Battery
« Reply #1 on: February 01, 2009, 10:12:00 pm »
Never could figure that out myself - it is a major pain to try to get to the battery.  I just wired a powerlet socket to the battery and plug my tender right into it.  Very convenient.  The powerlet is mounted on the black plastic part of the fairing that is underneath the handlebar.  
Augusta, GA  COG Member  Blue Knights IV  MSF RiderCoach    "It's always easier to beg for forgiveness than to ask for permission!"

Offline Charles W. (Chuck)_Hoefflin_IN

  • Training Wheels
  • *
  • Posts: 65
  • AREA: North Central Area
  • COG#: forum
  • Membership Level: Forum Subscriber
Battery
« Reply #2 on: February 08, 2009, 08:36:00 am »
I've got an auxillary fuse box connected directly to the battery that I use for my electrical accessories.  One of the connections to it ends in a two-wire SAE plug that I use for either my heated jacket or my battery tender.  

VirginiaJim

  • Guest
Battery
« Reply #3 on: March 07, 2009, 10:18:00 am »
I don't have a charger on mine as I haven't had any starting issues with it after sitting for more than a month.  It doesn't draw that much just sitting unless you have a vampire farkle taking more than the stock amount of juice.  Some of the sealed batteries coming with the bike have been defective out of the box and won't keep a charge, though.  How long are you letting it sit and have you had any starting issues?  08 Concours 14  King George, VA

Offline Fred_Harmon_TX

  • COG Technical Editor
  • Industry Member
  • Iron Butt
  • *
  • Posts: 3154
    • Angel Ride Videos
  • AREA: South Central Area
  • COG#: 2170
  • Membership Level: Active
Battery
« Reply #4 on: March 09, 2009, 10:51:00 am »
If you remove the right side plastic cover over the battery, you can access the positive battery terminal under the red rubber boot. I think you can get a small alligator clip lead on the positive terminal without removing the metal cover plate, however, access is pretty tight and you would have to use great care to make sure it didn't short out to the the frame (ground). You can use the frame of the bike for the ground connection.    Most folks, myself included, have hard wired on a small SAE type plug to the battery to allow easy connection to a "Battery Tender" type monitor/charger. Just be sure to put a fuse on it, and mount the fuse as physically close to the battery as possible. This will protect the battery and wiring in the event the positive side of your newly added lead shorts out somehow. You will probably need to remove the large metal cover plate over the battery if you want to add a permanent connector plug,      
« Last Edit: March 09, 2009, 10:27:00 am by Fred_Harmon_TX »
Fred H.


Thanksgiving Sale in Effect now!  Concours 1400 Maintenance Videos 
http://www.angelridevideos.com

Offline Boburns

  • Scooter
  • ***
  • Posts: 270
  • AREA: Northwest Area
  • COG#: Forum
  • Membership Level: Forum Subscriber
Battery
« Reply #5 on: March 09, 2009, 01:25:00 pm »
I run mine through the Powerlet receptacle I use for my GPS.   Bob "Flylooper" Burns  COG #5887  E Clampus Vitus, YB#1  '04 FJR 1300  
Bob "Flylooper" Burns  COG #5887  Former Editor, The Concourier  E Clampus Vitus, YB#1; '04 FJR 1300