Author Topic: 2003 Honda Goldwing ABS. 75,000 miles. Excellent Condition. $12,900  (Read 129 times)

0 Members and 1 Guest are viewing this topic.

Offline WingCon

  • My other motorcycle is (make that was) an Airbus A320.
  • Scooter
  • ***
  • Posts: 270
    • Motorcycle trip round trip Tacoma, WA to Prudhoe Bay, AK
  • AREA: Northwest Area
  • COG#: 9825
  • Membership Level: Active
In excellent condition. Black 2003 Honda Goldwing ABS. Never been down. One owner. 75,xxx mi. All maintenance either shop or owner complied with. Have all receipts. All recalls complied with. This bike has been babied from the day I rolled it off the showroom floor. Installed Dunlop Elite IVs about 3,000 mi back. They're in great condition. Oil changes every 3,000 mi at least. Frequent clutch, brake, and coolant changes. 

Enormous amount of accessories. I'm only pricing in the accessories at about 20% of what I paid for them, which of course doesn't include the many hours of labor. Easily over $7K into the accessories alone. Just a couple minor cosmetic issues. 

Most all miles are touring miles. Never commuted on it and no city riding. Only selling as I bought a sports car and have dedicated it and a GSX-R600 to the track.  Might pick up a new Wing next year.This bike also has a Bushtec trailer hitch frame and wire harness installed, normally not visible unless included hitch is dropped in for use. Wired for two electric vests with powelets, plug-in battery tender, and powerlet charging for your electronics- phone iPad, etc. in the left saddlebag.

Nicely chromed and lit up with aftermarket lighting and brake flashers. Full OEM shop manual included also. Includes full cycle cover with Goldwing logo and separate seat cover. To outfit a used Wing with everything I have on it listed below at today's prices would easily run near $20K.

A few highlights here, and a list of accessories below.Winter 2016   7 main engine cooling hoses replaced and new reservoir   All new normal and bright headlamps   New Galfer custom rotors   New OEM wheel bearings   New F4 scratch resistant windshield with vent   New "carbon fiber look" meter panel   New vented belly pan   New right side fairing storage box, release mechanism and cable   New speaker covers   New trunk gasket and aftermarket trunk bumpers for better trunk remote release   Cleaned and re-oiled K&N air filter   Custom seat bolt set for easier seat installation   Checked torque on multiple normally hard to reach fasteners

Accessories-

•   CB radio      •   Fog lights•   Rear speakers•   Pass intercom/CB controller•   Bushtec trailer hitch/harness. Hitch frame installed. Hitch and ball assy. is removable, and is lockable when installed. Hitch frame and electrical connector for trailer lights not visible when hitch and ball assy. is not installed for pulling a trailer. All included. All you need is Bushtec trailer.•   New wheel bearings at 65,000 miles•   7 cooling hoses replaced at 65,000 miles•   Heated grips•   Driver and Passenger Vest Powerlet outlets. Rear also subs as battery charger input   LED gear indicator•   LED Tire pressure monitor•   Passenger pouch•   Custom antenna that takes the place of the two OEM antennas. (Not shown but included.)•   Luggage rack with risers•   Trunk lid organizer•   Carbon fiber look meter panel•   Custom Galfer heavy braking capable front rotors•   L.E.D. chrome trunk molding•   L.E.D. chrome saddlebag molding•   L.E.D. mirror turn signal lights•   L.E.D. battery gauge•   F4 Custom scratch resistant windscreen with vent. Installed at 65K miles•   K&N lifetime air filter•   Tank knee pads•   Brake light flasher•   Intercom wind noise in line dampener•   12V accessory Powerlet sockets for vests, device chargers etc. Left saddlebag for passenger access and meter panel for driver access. Saddlebag outlet hotwired for battery charger use when ignition off•   Two RAM clutch and front brake reservoir mounts on both sides of handlebars for cell phones, GPS devices etc•   Trunk lid "rubber baby buggy bumpers"•   Passenger drink holder•   Aux switched fuse panel•   Full Cycle cover with Goldwing logo•   Seat cover•   Custom seat bolts to make seat installation much easier•   Trunk net and saddlebag nets•   Trunk and saddlebag mats•   Trunk storage unit•   Trunk and saddlebag luggage•   Handbook portfolio•   Chrome fairing intake grills•   Chrome handlebar end set•   Chrome master cylinder covers•   Chrome kill switch cover•   Chrome lower fairing vents•   Chrome gas lid•   Chrome ignition switch surround•   Chrome radio buttons•   Chrome fairing accents•   Chrome passenger floorboard covers•   Chrome saddlebag scuff covers•   Chrome cord clips•   Chrome Large foot kickstand (Duckfoot)•   Chrome fairing molding•   Chrome mirror backing•   Chrome radiator grills•   Chrome nose trim•   Chrome front fender inserts•   Chrome rear fender strip•   Chrome reflector grills for front fender•   Chrome left and right fairing panels. (Fog light/suspension and heated grip areas)•   Throttle cramp buster hand support•   Vented engine belly pan for engine damage protection and improved crosswind control•   Right and left fairing pockets with multiple storage pockets• 

Servicing complied with by dealer or self. Have all receipts•   Mostly touring miles. Never commuted on it. 
« Last Edit: September 26, 2017, 07:45:21 pm by WingCon »
http://alaskaprudhoebaymotorcycletrip.wordpress.com/

2003 Honda Goldwing 1800
2006 Suzuki GSX- R600
2015 Z51 Corvette Stingray