• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

Murph's lowered driver pegs

U

UP

Bicycle
Got a pair of Murph's lowered driver pegs and like them a lot for the additional leg room, however, I'm having problems adjusting the rear break pedal low enough so I don't have to lift my foot to apply the break. I've raised the adjusting nut as far up as it will go. Is there something else I can do? UP
 
You might need to remove the pushrod and shorten it slightly and I have read where you might also need to remove one of the lock nuts to get the pedal low enough for your liking. The pegs are probably from Steve from sunny Florida if they use the Gold Wing foot peg, shoot him an email or check his site at http://www.shoodabenengineering.com/
 
The best answer would probably come from BDF. But I don't think he's on this forum. You may have to contact him through Rick's forum. But Brian helped in the design and evaluation of Murph's new pegs. So I guarantee you that he'll be able to tell you exactly what to do. Bionic Bob COG & AMA member First C14 CDA member #0220 2008 C14 & 2003 Mean Streak
2638311280103513287fDmUTZ_th.jpg
 
You must log in or register to reply here.
Top