Let’s modify a Triumph Trident rear sprocket to work on an “ancient” late ‘40s Velocette rear hub.
The piece you see in the mill is a stepped slug I turned to insure the rotary table is dead center with the quill once the end mill is inserted.
Still in the layout stage, and hope to have everything centered up and concentric so I can make some chips before the w/e. Basically, one shot at this, so keeping fingers crossed.
The piece you see in the mill is a stepped slug I turned to insure the rotary table is dead center with the quill once the end mill is inserted.
Still in the layout stage, and hope to have everything centered up and concentric so I can make some chips before the w/e. Basically, one shot at this, so keeping fingers crossed.