Hello,
Purchased a set of Progressive Springs for my '99 Connie because I wanted to improve the front end handling. Observed that the new set are shorter than those already in the bike. Checked the Clymer manual and figured out the new springs meet the specs for the 1986-1993 models but are shorter than the spec calls for on post-94 bikes like mine.
Questions:
1. Should I use the Progressive springs anyway? If so, what mods are suggested, if any?
2. The current springs are in spec according to Clymer. I just wanted an improved front end handling. Should I just cut the spring and add a PVC spacer? What length space is recommended for a 210 lb rider?
3. Should I consider using the Progressive Springs AND a PVC spacer? Again, what length spacer is recommended under this particular scenario?
Eagerly awaiting a response as the bike is on the stand as I write this. And, Thanks!
Purchased a set of Progressive Springs for my '99 Connie because I wanted to improve the front end handling. Observed that the new set are shorter than those already in the bike. Checked the Clymer manual and figured out the new springs meet the specs for the 1986-1993 models but are shorter than the spec calls for on post-94 bikes like mine.
Questions:
1. Should I use the Progressive springs anyway? If so, what mods are suggested, if any?
2. The current springs are in spec according to Clymer. I just wanted an improved front end handling. Should I just cut the spring and add a PVC spacer? What length space is recommended for a 210 lb rider?
3. Should I consider using the Progressive Springs AND a PVC spacer? Again, what length spacer is recommended under this particular scenario?
Eagerly awaiting a response as the bike is on the stand as I write this. And, Thanks!