Good day to all. I have installed two driving lights on my canyon bars.
There are pre wires under the seat I could use to power these.
I looked thru my manual and it looks like there may be some prewired accessory leads under the front left panel under the handle bars.
Could anyone confirm this?
My hope is to tie in there rather than running back to under the seat.
Don’t want to pull off the front plastics until I get confirmation there is power available there.
Will install a water proof switch on the dash in the capped location on the left side and of course run a fuse.
I’m not an electrician so would appreciate some of the excellent advice out there.
Thanks
Woody
There are pre wires under the seat I could use to power these.
I looked thru my manual and it looks like there may be some prewired accessory leads under the front left panel under the handle bars.
Could anyone confirm this?
My hope is to tie in there rather than running back to under the seat.
Don’t want to pull off the front plastics until I get confirmation there is power available there.
Will install a water proof switch on the dash in the capped location on the left side and of course run a fuse.
I’m not an electrician so would appreciate some of the excellent advice out there.
Thanks
Woody